|
Zinc
wire is primarily used for metal spraying on iron and steel parts for
protection against atmospheric and galvanic corrosion. Metal spraying
is also employed for building-up worn metal surface and recommended
where hot dip galvanizing is not physically and economically feasible.
High quality material: all out
products are produced in a strictly process under
ISO 9001 quality control management.
| Purity is more than 99.995% with low percentage
of impurity. |
| Remarkable adhesiveness. |
| The surface of wire should be clean, smooth,
and free from blister & roughness. |
Mechanical Properties
| Elongation (%) |
40-42% |
| Density (g/cm3) |
7.14g/cm3 |
| Melting point (ºC) |
419ºC |
| Boiling point (ºC) |
907ºC |
| Tensile strength (N/mm2) |
11.2 N/mm2 |
Diameters and Tolerance
| Wire is available in the following diameter: |
2.00, 2.50, 3.15, 4.00 (mm) |
| The tolerance on diameter of the wire shall be: |
+0, -0.05(mm) |
Packing
Zinc wire shall be supplied in coils
of continuous lengths, closely coiled without any loose turns. The
inner diameter of the coil shall be 300-600 mm. The coils shall be
bound and fastened compactly at two places on the opposite ends of a
diagonal of the coil using binding wires. Inside, the coil is packed by
polythene and outside, by Hessian cloth. Zinc wires and accessories shall be supplied in coils of
continuous lengths, closely coiled without any loose turns. The inner
diameter of the coil shall be 300-600 mm. The coils shall be bound and
fastened compactly at two places on the opposite ends of a diagonal of
the coil using binding wires. Inside, the coil is packed by polythene
and outside, by Hessian cloth.
|
